Filter
Top Products
MinLasers 2.0 User Manual 9 August 2011
3. SETUP
AC Power
This product includes an external power supply which is auto-ranging and runs on
100~240 VAC, 50/60 Hz power. Only use the included power supply! To obtain a
replacement power supply, contact Chauvet®.
To determine the power requirements for a particular product, see the label affixed to the
back plate of the product or refer to the product’s specifications chart. A product’s listed
current rating indicates its average current draw under normal conditions.
Always connect the product to a switched circuit. Never connect the product to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
Mounting
Orientation
The MiN™ Laser FX 2.0/RGX 2.0
may be mounted in any position provided there is
adequate room for ventilation.
Rigging
Be sure that the structure can support the weight of the product. Please see the
“Technical Specifications” section of this manual for a detailed weight listing. Mount the
product securely. Do this with a screw, nut and bolt, or a hanging clamp. When rigging,
consider routine maintenance. Please see the following notes on installation.
When aiming the products, you may use the bracket adjustment knob(s). Loosen
the knob(s), adjust to the desired angle, and then tighten the knob(s) by turning
clockwise. Do not use tools for this step, as it may cause damage.
Use the floor stand to support the product in a sitting position.
Continued on next page
Angle Adjustment
Knob
A
Adjustable Stand
Angle Adjustment
Knob B
Power Supply