Filter
Top Products
Installation Instructions MSS6000
9
Display Swivel Tension Adjustment
Display swivel tension is pre-set at the factory. Swivel tension
will vary depending on the weight of display being mounted.
If swivel tension adjustment is required:
1. Disconnect all cords and cables from display.
2. Follow steps in Removing Display from Mount section.
3. Lay mount on back. (See Figure 11)
4. Locate three tension adjustment screws. (See Figure 11)
5. Turn each adjustment screw either clockwise to increase
tension, or counter-clockwise to decrease tension.
NOTE: It is important that all adjustment screws are turned
equal amounts in the same direction for the display to
turn properly.
Figure 11
6. Install display following the instruction outlined in Display
Installation section.
7. Test display swivel tension by grasping each side of display
and turning display left and right.
If additional swivel tension adjustment is required, repeat steps
1 through 7 above.
Display Swivel Stop Location Adjustment
The MSS6000 allows for the installation of swivel stops that
limit the amount of display travel. Stops can be installed at +/-
15°, 25° or 35°.
1. Follow steps 1 through 3 of Display Swivel Tension
Adjustment section.
2. Insert one 10-24 X 1/2” Phillips head cap screw in one of the
three swivel stop holes (15°, 25° or 35°) in the base of the
stand. (See Figure 12)
Figure 12
Cable Management
The MSS6000 has been designed to provide multiple cable
management/routing options.
Option A
Option A does not use the cable access features of the
MSS6000 and simply routes the cables away from the display
and mount. (See Figure )
Figure 13
Tension Adjustment Screw
(Turn left to decrease tension
Turn right to increase tension)
35°
25°
15°
Cable
Access