Filter
Top Products
Installation Instructions PCM SERIES
5
Figure 5
Adjustments
The PCM is designed to accommodate 5" of display height
adjustment, 4º right and left display roll adjustment, and 15º
down/5º up display pitch (Tilt) adjustment.
Remove display before performing adjustments.
Display Height Adjustment
To adjust display height:
1. Loosen four 5/16-18 button head cap screws using 3/16"
hex wrench (C). (See Figure 6)
2. Adjust faceplate to desired position. (See Figure 6)
3. Tighten four 5/16-18 button head cap screws using 3/16"
hex wrench (C). (See Figure 6)
Figure 6
Display Roll Adjustment
To adjust display roll:
1. Loosen 3/8-16 Nylock nut. (See Figure 7)
2. Adjust faceplate to desired position. (See Figure 7)
3. Tighten 3/8-16 Nylock nut. (See Figure 7)
Figure 7
Display Pitch (Tilt) Adjustment
To adjust display pitch:
1. Loosen four 5/16-18 button head cap screws.
(See Figure 8)
2. Adjust to desired tilt position. (See Figure 8)
3. Tighten four 5/16-18 button head cap screws.
(See Figure 8)
Figure 8
2
1
A padlock or bolt may
be placed through latch holes
To use as a
more permanent
lock, remove pin
and nuts and move
to lower holes
3
1
2
3
1
2
3
1
2