Filter
Top Products
TB731P/TB732P/TB733W 25
English
Installation and Wire
connection manual
24 TB731P/TB732P/TB733W
English
Installation and Wire
connection manual
■
Fixed Mount (TOYOTA, NISSAN and other ISO/DIN equipped vehicles)
This unit is designed for fixed installation in the
dashboard.
If the vehicle is equipped with a factory-installed
radio, install the main unit with the parts and
screws marked (*) (Figure 8).
If the vehicle is not equipped with a factory-
installed radio, obtain an installation kit to install
the main unit in the following procedure.
1. Remove the screws at both sides of the
main unit and slide the springs to the
direction of arrow and remove them (Figure
7).
2. Secure the mounting brackets to the chassis
as shown in Figure 8. Holes are pre-tapped
for TOYOTA and NISSAN vehicles;
modification, such as drilling new holes, of
the mounting brackets may be required for
other models.
3. Wire as shown in Section 7.
4. Secure the unit in the dashboard, and then
reassemble the dashboard and the center
panel.
*: The parts and screws with this mark
are used to install radio or included in
the installation kit.
The parts and screws with this mark
are originally attached to the vehicle.
★:
Center Panel (Note 1)
Main Unit
Mounting bracket ★
(1 pair for the left and right sides)
Dashboard
Pocket
★
★
★
★
4–Hexagonal screws * (M5 × 8)
Main Unit
2–Springs
Figure 7
Figure 8
2–Screws
Screwdriver
★
★
★
★
Note 2
Note 1: In some cases, the center panel may
require some modification (trimming,
filling, etc.).
Note 2: If a hook on the installation bracket
interferes with the unit, bend and flatten it
with a nipper or a similar tool.
6. REMOVING THE MAIN UNIT
7. CAUTIONS ON WIRING
1. When the rear of the main unit has been
secured with the method shown in Figure 6
unfasten the special screw.
2. Remove the outer escutcheon.
3. Insert the hook plate between the spring and
the universal mounting bracket, fit tab B of
the spring into hole A of the hook plate,
then pull the main unit out by the hook plate.
(Insert both the right and left edges of the
hook plate.) (Figure 9)
Note:
Keep the hook plate. You cannot remove the main
unit without disengaging the hook plate.
2–Hook plates
Spring
Universal mounting bracket
Instrument panel
Figure 9
A
B
Outer escutcheon
Main
Unit
1. Be sure to turn the power off before wiring.
2. Be particularly careful where you route the
wires.
Keep them well away from the engine, and
exhaust pipe, etc.
Heat may damage the wires.
3. When connecting the ground lead, fasten
the ground lead (black) securely to a clean
metal plate on the car. (Figure 10)
If the set is insufficiently grounded, it may
not operate or there may be noise.
4. If the fuse should blow, check to see if the
wiring is correct.
If it is, replace the fuse with a new one with
the same amperage rating as the original.
5. To replace the fuse, remove the old fuse of
the power supply lead and insert the new
one (3A). (Figure 11)
After the connection, fix the lead by a clamp
or insulation tape for protection.
CAUTION
Screw on car
Fasten securely to a clean
metal plate on the car.
Figure 10
Fuse
Fuse holder
Figure 11