Filter
Top Products
With the VDH9600, OHM641 and the FM100S
1. Pick a location to mount the tuner. Typically the tuner will be located close
to the VCP. Avoid areas with excessive heat or moisture and mount the
tuner.
2. Mount the TV antenna (ZCB-003 or equivalent) and plug into the tuner.
3. Plug the 16 pin to A/V out connector into the tuner. Plug the A/V RCA
cables, IR extension and power plug into the 16 pin connector and run to
the video player.
4. Plug the A/V RCA cable into the A/V input of the player. Plug the Y
connector into the player and plug the IR extension into the Y connector.
5. At the OHM641, plug the IR extension and power cables supplied with the
OHM641. Run these cables to the back of the video player. Plug the video
RCA into the video output of the player. Plug the IR extension into the
other leg of the Y connector. Tie all the power wires together. These wires
will be run to the radio location.
6. Plug the audio RCA cable into the audio output of the player and run the
audio RCA and main power cables to the radio location. Remove the radio
and plug the audio RCA into the FM100S audio inputs.
7. Mount the switch for the FM100S and run its power wire to the radio
location. The power and ground wires of the TTX001, video player,
OHM641 and the FM100S can be joined and connected to the radio
accessory and ground wires.
8. Plug the vehicle antenna into the antenna input of the FM100S. Plug the
antenna output of the FM100S into the radio.
9. The FM 100S has a two position switch to select the modulation frequency.
Pick the frequency that has the least amount of radio reception and set that
frequency on the modulator and into a radio preset memory.
Operation
• Similar to a home system, the VDH9600 allow their auxiliary A/V inputs to
loop through to their A/V outputs when they are not playing a video tape.
• Because the IR lines have been linked together, each component can be
controlled by its respective remote control when pointed to the IR eye
located on OHM641.
• Turn the vehicle ignition switch to the accessory position. Point the video
player remote at the IR eye and press power to turn on the player. Point the
remote (RC-300) at the IR eye and press power to turn on the tuner.
• You should now see the TV displayed on the monitor.
• Turn the modulator and the radio on and tune to the modulated frequency.
Turn the FM100S’s switch on. The audio can now be heard over the sound
system. You can control the video player and the TV tuner by pointing their
respective remotes at the IR eye in the monitor.
6