Filter
Top Products
Important information
Handling instructions
The DVD player's top and back panel may
become warm after prolonged use. This is not due
to a defect.
When the DVD player is not used, remove the
disc and turn off the device.
If the DVD player is not used for a long period, its
function may deteriorate. Therefore, the DVD
player should be turned on and used now and
then.
Protect the power cord
Follow the instructions below to avoid irregular
function, electric shock, fire, or injury:
Hold the plug firmly when inserting it into the
socket
Avoid heat-producing devices
Do not place objects on the power cord
Do not carry out service work on or change the
power cord
Positioning
Do not place the device in any of the following
places:
In sunlight, close to heat-producing devices and
in a closed trolley
At high temperatures (40ºC or above) or high
relative humidity (90% or more)
In dirty places as some internal parts may be
damaged
Do not put your fingers or any
other objects into the device
Touching the internal parts is dangerous and may
cause injury or damage. Do not open the
housing.
Do not place foreign matter on the drive.
Interference
Placing the DVD player near a television set,
radio or video player may cause poor picture and
sound quality. In that case, move the DVD player
further from television set, radio or video player.
Condensation
Condensation may occur in the following cases:
When the DVD player is moved directly from a
cold to a warm place.
When the DVD player is used in a room where
the radiator has just been switched on or where
the cold air from the air condition plant is directed
at the device.
If the DVD player is used in the summer in a
warm and humid room just after it has been
removed from an air conditioned room.
If there is steam or a high level of humidity in the
room.
In case of condensation, the DVD player will not
work properly. Remove the disc and turn off the
device. Unplug the device and leave it for 2-3
hours. The DVD player will then have adapted to
the environment and any condensation will have
disappeared.
NOTE:
An Ø may appear on the screen when the
device is turned on. This means that the
required operation is not available.
07