Filter
Top Products
9323 Owner’s Manual •
••
• (V 2.1) Page 19 of 28
Information Submenu
Menu Structure Parameter Type
Info +POW Positive Watts Consumed
-POW Negative Watts Consumed
SWR# Software Release Number
SWB# Software Build Number
Positive Watts Consumed
A read only indication of power consumed by the card from the frames +12V rail.
Negative Watts Consumed
A read only indication of power consumed by the card from the frames +-7.5V rail.
Software Release Number
A read only indication of the software release number. A higher number is newer release of software.
Software Build Number
A read only indication of the software build number. Software build number is an internal indicator
used by Cobalt engineers to differentiate different software builds.
Factory Default Settings
Factory Default Settings
The factory default settings are as follows
1) The proc module has all parameters set to unity.
2) The audio mapping is for simultaneous embedding and de-embedding. Discrete AES inputs 1-16
are mapped to embedded audio outputs 1-16. Embedded audio inputs 1-16 are mapped to discrete
AES outputs 1-16.
3) Audio gain is set to 0dB and polarity is set to normal on all channels.
4) AES IN/OUT switches are set to output AES.
AES IN/OUT Switch Settings
Switches S11 – S14 determine whether the AES IN/OUT ports on AES I/O 1-4 are set to input AES or
output AES.
1) Switching S11 up configures AES I/O 1 as AES IN, switching S11 down configures AES I/O 1 as
AES OUT.
2) Switching S12 up configures AES I/O 2 as AES IN, switching S12 down configures AES I/O 2 as
AES OUT.
3) Switching S13 up configures AES I/O 3 as AES IN, switching S13 down configures AES I/O 3 as
AES OUT.
4) Switching S14 up configures AES I/O 4 as AES IN, switching S14 down configures AES I/O 4 as
AES OUT.