Filter
Top Products
© 2001 Firstech, Inc. Page 7
your car that prevents you from starting your car even with a manual key when
your vehicle’s alarm mode is activated.
Note: If you lose your remote after you have armed the vehicle, use your key to
open the vehicle. The siren will go off. Turn on and off ignition 5 times with your
key to shut off the siren and turn the system into valet mode. Cancel the valet
mode with remote later. See Valet mode.
Note: (Siren duration is 30 to 60 sec depending on the options set at the time of initial
installation.)
Dual Stage Shock Sensor
Press Buttons (I+III) for 2 seconds to activate or deactivate the dual stage shock
sensor. The dual stage shock sensor will activate 30 seconds after the
CompuStar alarm mode is armed. When the dual shock sensor is engaged, the
remote-pager security alerts will be triggered by the following:
I. Light impact to your vehicle will activate the first stage shock sensor
and the car siren will chirp 4 times in addition to the parking lights flashing
4 times. The remote pager unit will beep and the hammer icon shows up a
couple times
II. Heavy impact to your vehicle will activate the second stage shock
sensor and the car siren will chirp for 30 to 60 seconds and the parking
lights will flash for 30 to 60 seconds. The remote-pager will be notified
audibly and a hammer icon will blink in the CompuGLO LCD. Press
Button I for a ½ second to turn off the second stage shock sensor sirens
and flashing lights.
Auto-Start Function
Press Button II for 2 seconds to auto-start an automatic transmission engine.
Remember that a manual key in the ignition is required to drive the car. In
addition, the anti-grind circuit (this maybe an optional feature provided by your
installer) prevents you from re-cranking the starter on a remote-started vehicle.
Press Button II for 2 seconds in order to turn off an auto-started car. For manual
transmission vehicles, please use reservation mode.