Filter
Top Products
Internal Battery Pack for TPMC-8X Crestron TPMC-8X-BTP
TPMC-8X Internal Battery Switch
5. Re-attach the battery compartment cover using the two supplied
Phillips head screws.
Removal
Use the following procedure to remove the TPMC-8X-BTP from a
TPMC-8X touchpanel:
1. Place the touchpanel screen-side down on a clean, soft surface.
2. Remove the two Phillips head screws that hold the internal battery
compartment cover on the rear of the touchpanel.
3. Using the flat end of a small slot head screwdriver, gently pry the
multi-pin connector off the corresponding connector in the battery
compartment of the TPMC-8X.
4. With the multi-pin connector detached from the TPMC-8X, lift the
TPMC-8X-BTP out of the battery compartment.
6 • Internal Battery Pack: TPMC-8X-BTP Operations & Installation Guide – DOC. 6556