Filter
Top Products
Crestron MLX-2 infiNET EX
™
LCD Handheld Remote
Industry Compliance
As of the date of manufacture, the MLX-2 has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for a class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off or on, the user should:
Relocate or reorient the TV or radio antenna
Increase the separation between the device and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with FCC regulations, shielded cables must be used
with this equipment. Operation with non-approved equipment or unshielded cables is
likely to result in interference to radio and TV reception. The user is cautioned that
changes and modifications made to the equipment without the approval of
manufacturer could void the user’s right to operate this equipment.
Any changes or modifications to the equipment without Crestron’s express consent
will void the user’s right to operate this equipment.
FCC ID: MG3-30700
Compliance with IC Rules and Regulations
IC: 2575A-30700
Model: MLX-2
Object is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference
that may cause undesired operation of the device.
Operations Guide – DOC. 6739B infiNET EX
™
LCD Handheld Remote: MLX-2 • 5