Daewoo 20Q1 CRT Television User Manual


 
37
Stand-By Mode
While being in remote control stand-by mode, the output voltage is kept on providing to the secondary side and
the power transistor operates at A class mode.
By connecting INH terminal (Pin 6) to the GND, the OFF-time of the power transistor is fixed at set time
( T OFF = 50usec at Ta = 25 ) of the built-in oscillator, and only ON-time changes depending on input and output
conditions of the power supply.
Therefore, it enables to hold an oscillation frequency in light mode below 20KHz (typical).
(4) Drive circuit
The STR-S5707 applies the proportional drive system in order to minimize turn-on and saturation loss, and storage time.
(5) OCP (over-current protection) function
Over-current protection is performed pulse by pulse by directly detecting collector current of the power transistor.
Detecting voltage is set to -1V below a reference point of GND (ground).
(6) Latch circuit
It is a circuit which sustains an output from the oscillator low and stops operation of the power supply when over-voltage
protection (OVP) circuit and thermal shutdown (TSD) circuit are in operation.
As the sustaining current of the latch circuit is 500 A maximum when VIN terminal voltage is 4V, the power supply
circuit sustains the off state as long as current of 500 A minimum flows to VIN terminal from a start-up resistor.
In order to prevent a malfunction to be caused by a noise and so on, delay time is provided by C1 incorporated in the
IC and, therefore, the latch circuit operates when the OVP or TSD circuit is in operation, or an external signal input is
provided for about 10 sec or longer.
In addition, even after the latch circuit start operating, the constant voltage regulator (Reg) circuit is in operation and the
circuit current is at high level.
As a result, VIN terminal voltage rapidly decreases.
When VIN terminal voltage becomes lower than the shutdown voltage, VIN(OFF) (4.9V typical), it starts increasing as the
circuit current is below 500 A.
When it reaches the ON-state voltage, VIN (ON) (8V typical), VIN terminal voltage starts decreasing because the circuit
current increases again.
When the latch circuit is on, VIN terminal voltage increases and decreases within the range from 4.9V typical to
8V typical and is prevented from abnormally rising.
Cancellation of the latch is done by decreasing VIN terminal voltage below 3.3V.
The power supply can be restarted after disconnecting an AC input to the power supply once.
(7) Thermal shutdown circuit
It is a circuit to trigger the latch circuit when the frame temperature of the IC exceeds 150 (typical).
Although the temperature is actually sensed at the control chip, it works against overheating of the power transistor
as the power transistor and the control IC are mounted on the same lead frame.
(8) Over-voltage protection circuit
It is a circuit to trigger the latch circuit when VIN terminal voltage exceeds 11V (typical).
Although it basically functions as protection of VIN terminal against over-voltage, since VIN terminal is usually supplied
from the drive winding of the transformer and the voltage is proportional to the output voltage, it also functions against
the over-voltage of secondary output which causes when the control circuit opens or in some other events.