Daewoo DTH-14/20V1FSN Flat Panel Television User Manual


 
8
User’s Instruction
Operating Your TV
Once you have connected your TV to an antenna or cable system, plugged the TV in, and put batteries in the remote, you
are ready to use the TV. The first thing you should do is program your TV so it memorizes all of available channels.
Turning Your TV On
Programming Your TV’s Channel Memory
Your TV’s memory determines the channels that are availablee using the CH buttons. If a channel is not in memory,
you can tune to it with the number buttons, but not with the CH buttons. Follow these steps to program your TV’s
memory :
1 With the TV on, press the MENU button twice, then “ Set-Up ” menu will appear.
2 Use the CH buttons to select “ Reception ”, the use the VOL button to select ‘Air’ or ‘Cable’. If you
connected an antenna to your TV, select ‘Air’ : If you connected a cable system, select ‘Cable’
3 Use the CH buttons to select “ Memorize Channels ” , then use the VOL button to enter the “ Memorize
Channels ” process. Again press the VOL button to begin.
4 Press the MENU button to return to Set-Up menu.
5 Press the MENU button three times to return to normal TV viewing.
Your TV’s channel memory will not be affected by a power outage. You will not need to re-program the memory unless you
change the type of cable or antenna connected to your TV.
1 To turn your TV, press the POWER button on the front panel then.
press the CH , VOL or MENU botton.
You can also use the POWER button on the remote control.
Make sure your TV is plugged in before you try to turn it on.