Filter
Top Products
Chapter 5: DVR Setup - 5.12 Sub Menu-Time Set
To configure the DVR's time:
Press [ Up] and [ Down] to move
prompt.
Press [ Select] to modify.
Press [ Menu] to save and exit.
Q-See Q25DVR4ES User's Manual
Chapter 5: DVR Setup - 5.13 Hard Disk Setup
OVERWRITE ENABLED:
If you choose YES, recording continues
and overwrites previous recordings when
the hard drive is full. If you choose NO,
the recording process stops when the
hard drive is full.
HDD SIZE: This shows the size of the
hard drive installed in the DVR.
HDD USED: This shows the space used
up on the hard drive and the
percentage of hard drive space being used.
master
HDD FORMAT:
If you format the hard drive, it will erase all the data on the hard drive.
Note: When you install a new hard drive in the DVR, please use this
function to format the hard drive.
Chapter 5: DVR Setup - 5.14 Motion Setup
Page 13
Page 14
Q-See Q25DVR4ES User's Manual
CHANNEL SENSITIVITY:
Press [ Select] to adjust sensitivity of motion
detection on each channel.
High (1----------9,OFF) Low
When it's OFF, the channel cannot be triggered
by movement.
CHANNEL AREA SET:
Press Select to enter the sensitive area of each camera. The picture
of the selected channel is divided into 144(12*12) blocks, press [REW] to
move left, press [FWD] to move right, press [UP] to move up, press
[DOWN] to move down, press [ Select] to set the block to being active or not.
When the block is transparent, it's active to record. When the block is
covered by shadow, it is not active, and motion in this area will NOT be recorded.
Make sure Record Schedule is set to Motion for the times required.
After completing the MOTION SETUP , User can exit by clicking
[ Menu], and press [ Record] to start Motion Recording.
MOTION RECORD TIME:
This number indicates how long the triggered
recording lasts after the DVR has been triggered by
motion.
MOTION ALARM TIME:
This number indicates how long the buzzer inside
the DVR will sound when a motion event has been
detected.
MOTION SET:
User needs to have video record method set to
Motion Trigger. (Refer to 5.7 Schedule Set)