Directed Electronics 110XV Universal Remote User Manual


 
24
© 2004 directed electronics, inc.
NPC
ignores, or bypasses, that sensor or switch (along with any
other sensors or switches sharing the same zone) for 60 minutes.
If the bypassed sensor tries to trigger the security system while it
is being bypassed, the 60-minute bypass period will start over.
This ensures that a sensor that is continually being triggered will
remain bypassed.
The vehicle doors are protected by NPC
differently. If your
security system is triggered by an open door for three full cycles,
the system will bypass the doors until the trigger ceases.
ddiiaaggnnoossttiiccss
The microprocessor at the heart of your system is constantly
monitoring all of the switches and sensors connected to it. It is
designed to detect any faulty switches and sensors and prevents
them from disabling the entire system. The microprocessor will
also record and report any triggers that occurred during your
absence. Refer to the System Status Chirps and Table of Zones
sections of this guide for diagnostic information.
note: Arming and disarming the system does not reset
this function! The only ways to reset a bypassed zone are
for it to not trigger for 60 minutes, or to turn on the igni-
tion. If testing your system, it is important to remember
that the NPC
programming can cause zones to be
bypassed and appear to stop working. If five chirps are
heard when disarming, NPC
has been engaged. If you
wish to clear the NPC
memory, turn the ignition on.