Directed Electronics 259D Universal Remote User Manual


 
39
© 2002 directed electronics, inc.
The vehicle starts, but the starter keeps running.
Is the system programmed for engine checking off or voltage
sense? When programmed for either of these features, the
engine cranks for the preprogrammed crank time regardless
of how long it takes to start the vehicle to actually start.
Adjust to a lower cranking time.
Was the Tach Learn successful? The LED must light solidly
and brightly to indicate a successful learn.
Make sure that there is a tach signal right at the
purple/white tach input wire of the remote start. If not,
recheck the connection to the vehicle’s tach wire and make
sure the wire is not broken or shorted to ground leading to
the remote start.
The vehicle will start and run only for about 10 seconds.
Is the remote start programmed for voltage sense? Try
programming the unit for low voltage reference. If this does
not work, a tach wire should be used.