Filter
Top Products
Getting started 5
Testing your system
When you have aligned your dish antenna to the azimuth and elevation angles
shown on the
Install pane:
1. Highlight the
Signal tab.
2. Use the button to highlight the Source pull-down menu
3. Signal quality is indicated by a scale at the bottom of the pane and with an
audible indication. The frequency and tempo of the tone increase with
signal strength.
4. Highlight the Transponder pull-down menu.
5. You may need to select another transponder to achieve the highest signal
indication.
6. Select the transponder providing the best signal.
7. Use the button to highlight the
Test tab.
8. Highlight Begin Test and press the
SELECT button.
Results appear within a few seconds and should resemble those in the figure.
If your test results are much different from those shown in the figures, or you
receive no signal indication, refer to page 6.
To perform the Transponder test:
1. Move the highlight to the Xponder Test pull-down menu.
2. Press the
SELECT button.
SIGNAL STRENGTH
Prefs
Install
Signal
Main Menu
Thu, Jun 14 4:14 PM
Test
New Card
Upgrades
Features
Watch TV
VCR
Status: Unlocked
04
Source
Transponder
Signal Strength
Current: 95 Highest: 95
Satellite 101
)
(A)
SYSTEM TEST
Prefs
Install
Signal
Main Menu
Wed, Jun 13 10:14 PM
New Card
Upgrade
Features
VCR
Watch TV
Xponder Test
System Tests
Begin Test
Version
Wink Version
Signal
Tuning
Phone
Access Card
: 5317.6
:0.0.0.75
:OK
:OK
:OK
:OK
Front Panel
:OK
(ID 0000-0000-0000)
Test