Filter
Top Products
Changing the Remote Control Address
16 104333
CHANGING THE REMOTE CONTROL ADDRESS
Note: Do not change the address of the remote unless absolutely
necessary
,
because the remote cannot control the receiver if the two
devices have different addresses. If you start doing this procedure and
then do not press any button for 20 seconds, the remote will end the
procedure. Just start over again.
Note: This procedure shows examples of menu options. The options
that you see may differ.
8. If the code you entered does not work, repeat steps 3 through 7
using another code from the tables.
9. If you have tried all of the codes listed for the device without
success, or if you cannot find the device brand name in the
tables, see Device Code Scan on pag e20.
1. Display the Important System Information menu.
Note the Remote Address shown on this menu.
To do this:
Either: Press the System Information
button.
or: a) Press the Menu button.
b) Select the System Setup option.
Note: This step does not apply
to some receivers.
c) Select the Installation option.
d) Select the System Info option.
or:
2. Press and hold the SAT mode button about three
seconds, until all the mode button backlights
come on, and then release the SAT button.
3. Use the number buttons to enter a number
from 1 to 15. The SAT mode button backlight
will blink off after you enter each digit, and then
come on again.