Filter
Top Products
6
SWITCHING BETWEEN TV AND AMPLIFIER VOLUME
C
ONTROL
When the remote control is set up to operate your TV, the MUTE and
VOLUME buttons will adjust your TV volume. To use the remote to
adjust the volume of a remote-controllable audio receiver or amplifier
instead of adjusting the TV’s volume setting, use the steps in the left
column of the table. To switch back to controlling the TV’s volume,
use the steps in the right column of the table.
7 Turn the equipment back
on and try some other
buttons to make sure they
work.
Press POWER to turn the
equipment back on. Try some
other buttons to make sure they
work. Sometimes POWER
works when other buttons
don’t, and more than one code
may work to turn equipment on
or off.
8 If necessary, repeat this
procedure until you’ve tried
all the codes.
You may need to repeat the scan
to find the best code for your
equipment.
Control Amplifier Volume Control TV Volume
1 Press and hold the AUX
mode button until all mode
buttons are lit, then release
it. The AUX mode button
will blink.
1 Press and hold the TV
mode button until all mode
buttons are lit, then release
it. The TV mode button will
blink.
2 Press the POUND (#)
button.
2 Press the POUND (#)
button.
3 Press the plus (+) side of
the VOLUME button.
3 Press the plus (+) side of
the VOLUME button.
4 Press the 0 number button. 4 Press the 0 number button.
5 Press the POUND (#)
button. The AUX mode
button flashes three times.
5 Press the POUND (#)
button. The TV mode
button
flashes three times.
Instructions Additional Information