Filter
Top Products
6
4 Press POWER. This puts your remote in the
scan mode.
5 Press the UP or DOWN
ARROW repeatedly until
the equipment turns off.
As you press the UP or DOWN
ARROW, the remote tries each
code in the memory to see if it
can turn off your equipment.
When the equipment turns off,
you have found a code that
might work.
Note: The mode button for the
equipment flashes rapidly eight
times when you’ve scanned all
the codes for that equipment.
6 Press POUND (#). The mode button flashes three
times if you have entered the
code correctly. This stores the
code you found.
7 Turn the equipment back
on and try some other
buttons to make sure they
work.
Press POWER to turn the
equipment back on. Try some
other buttons to make sure they
work. Sometimes POWER
works when other buttons
don’t.
8 If necessary, repeat this
procedure until you’ve tried
all the codes.
You may need to repeat the scan
to find the best code for your
equipment.
9 Once you find a code that
works, consider using
Limited Mode.
See page S-3, Placing Your
Remote in Limited Mode for
putting your remote in Limited
Mode.
Instructions Additional Information