Filter
Top Products
121716 11
4. Pressthe 0 number button.
5. Pressthe POUND (#) button.
The TV mode button flashes three times.
6. Pressthe SAT mode button.
7. Pressthe plus (+) and minus(-) sides of the VOLUME
button.
The TV’s volume changes and the TV mode button lights
instead of the AUX mode button.
REMOTE CONTROL BUTTONS
CONTROL THE RECEIVER
SAT MODE BUTTON
Press this button to set the remote to SAT (“satellite”) mode to control
the receiver. The SAT mode button’s back light stays lit for about two
seconds to show you’ve set the remote to SAT mode. Make sure you
keep the remote in SAT mode to use the buttons described here.
TV/VIDEO BUTTON
Ifyouconnectthe receiverwithitsback panel TV ANTENNA/CABLE
IN and TV SET OUT ports, use this button to switch the receiver
betweenthe satellite signal(connect it to the SATELLITE IN port) and
another video signal like a cable or broadcast TV antenna input
(connect it to the receiver’s TV ANTENNA/CABLE IN input).
Note: If you connect the receiver to other devices with the phono
(RCA) jacks or the S-VIDEO output, you must use the TV
menus to change the input from local broadcast TV to satellite
TV.
text_dishpvr.fm Page 11 Friday, February 28, 2003 1:22 PM