Dish Network EZ Universal Remote User Manual


 
118866 13
SETTING UPONTHEREMOTE CONTROL
1. In the blank below, write down your preferred off-
air channel that you want your TV to tune to when
you press .
2. If step 19 on page 11 is blank and was not used to
set up , go to step 8. Otherwise, go to step 3.
3. In the blank below, write down the number
sequence from step 19 on page 11.
4.
If the number you wrote in step 1 is a 2-digit number:
In the blank below, write the number sequence
from step 3, except replace
3”or“0-3” with your
2-digit number from step 1 (for example, if you
wrote “
0-3-SELECT” in step 3 and your preferred
channel is Channel 25, write “
2-5-SELECT”).
5.
If the number you wrote in step 1 is a 1-digit number:
In the blank below, write the number sequence
from step 3, except replace
3” with your 1-digit
number from step 1 (for example, if you wrote “
0-3-
SELECT
”instep3andyourpreferredchannelis
Channel 7, write “
0-7-SELECT”).
6. Write the number sequence you wrote in either
step4orstep5intotheblankinstep11onpage14.
7. Go to step 9.
8. In the blank provided in step 11, write the number
recorded in step 1. If that number has one digit,
write “
0” before the number.
9. Press and hold until both lights turn
on (it takes about five seconds).
SAT
TV