Filter
Top Products
121716 9
For AUX mode, the first group of flashes tells you what the
AUX mode controls. A quick flash (zero) before the three-digit
code is fora TV; one regular flash is for a VCR; and two flashes
is for a tuner, amplifier, or cable box. For example, if the TV
code is570, the AUX mode button flashesonce quickly, pauses,
flashes five times, pauses, flashes seven times, pauses, and
flashes once quickly.
CHANGE THE ADDRESS
Because UHF signals travel long distances and go through walls,
a neighbor’s remote may control your receiver by mistake. To handle
this problem, you can change the remote control and receiver address.
1. Open the Important System Information screen.
Press the receiver’s front panel SYSTEM INFO
button.
The Important System Information screen shows
a Remote Address.
Write down this number:
2. Press and hold the SAT mode button about three
seconds, until all the mode buttons light up,
and then let go of the SAT button. The SAT mode
button will blink.
3. Use the number buttons to enter any number
from1to16,butnot the one you found in step 1. The SAT
mode button goes out after you enter each digit, and then lights
up again.
Write down the number you entered:
4. Pressthe POUND (#) button.
If you entered the address correctly, the SAT mode
button will flash three times.
5. Pressthe RECORD button.
6. Make sure the Remote Address on the Important
System Information screen now is the same as the
one you entered in step 3. If it isn’t, the remote can’t
control the receiver.
7. To check the remote control address, press and hold
the SAT mode button for three seconds. Then, let go
of the SAT button, and press the POUND (#)button
twice.TheSAT mode button flashes the same number
of times as the address you entered in step 3.
text_dishpvr.fm Page 9 Friday, February 28, 2003 1:22 PM