Dish Network Platinum Remote Control Universal Remote User Manual


 
121716 31
TROUBLESHOOT THE REMOTE CONTROL
What’s
Happening
What’s Wrong What You Can Do
While you do
a remote
procedure,the
remotecontrol
“times out.”
Ifyoudon’tpress
any button
for20 secondsin
a programming
sequence,
the remote
“timesout.”
If you hold a
button longer
than two
minutes, the
remote control
stops
transmitting to
save battery life.
Start over again.
When you
press the
remotecontrol
Power button
to turn the
receiver on,
the receiver’s
front panel
Power light
doesn’t turn
on.
Maybe the
batteries are
weak or dead.
Maybeyoudidn’t
plug the receiver
powercordintoa
poweroutlet,or
maybe there’s a
problem with the
power.
Maybe the
remote isn’t in
SAT mode.
Maybe the
remote and the
receiver have
different
addresses.
Replace the remote batteries with
fresh ones.
Make sure the receiver power cord
is plugged into a power outlet.
PressSATto settheremoteto SAT
mode to control the receiver.
Make sure the remote and the
receiver have the same address.
SeeChange the Address on
page 9.
text_dishpvr.fm Page 31 Friday, February 28, 2003 1:22 PM