Filter
Top Products
Command Line Interface D-Link Web Smart Switch User Manual
9
9
5
5
DGS-1210-24:admin#logout
**********
* Logout *
**********
NOTE: Save your configuration changes before
logging out.
ping
Purpose This command is used to test the connectivity between the Switch
and other network devices.
Syntax
<ipaddr>
Description
The ping command checks if another IP address is reachable on
the network. You can ping the IP address through the managed
VLAN (VLAN 1 by default), as long as there i
s a physical path
between the Switch and the target IP equipment. By default, the
Switch sends five pings to the target IP address.
Parameters
<ipaddr> - Enter the IP address of the host.
Restrictions None.
Example usage:
To ping the IP address 10.90.90.6:
DGS-1210-24:admin#ping 10.90.90.6
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
Reply Received From :10.90.90.6, TimeTaken : 1 msecs
--- 10.90.90.6 Ping Statistics ---
5 Packets Transmitted, 5 Packets Received, 0% Packets Loss
DGS-1210-24:admin#
reboot
Purpose This command is used to reboot the Switch. If the Switch is a
member of a stack, it may be rebooted individually, without
affecting the other members of the stack.
Syntax
reboot
Description
The reboot command reboots the Switch. All network connections
are terminated and the boot code executes.
Parameters None.