Filter
Top Products
Appendix B - Technical Specifications D-Link Web Smart Switch User Manual
1
1
0
0
2
2
- DSCP
- ToS
- TCP/UDP port number
Up to 8 queues per port
Supports Strict / WRR mode in queue
handling
Bandwidth Control
AAA
802.1X port-based access control
Support RADIUS server
ACL
Max 50 ingress ACL profiles
Ingress ACL rules:
- Total 200 rules (each rule can be
associated to a single port or multiple
ports)
Support different ACL policy packet
contents:
- MAC address
- Ethernet Type
- IPv4 address
- ICMP
- IGMP
- TCP/UDP port number
- Protocol ID
Security
Trusted Host
Port Security: Support 64 MAC addresses
per port
DoS Attack Prevention
Traffic Segmentation
D-Link Safeguard Engine
Broadcast Storm Control
ARP Spoofing Prevention: Supports max
64 entries
DHCP Server Screening: Able to
configure 5 IP addresses for DHCP server.
SSL: Support v1/v2/v3
OAM
Cable Diagnostics
Reset button (reset to factory default)
Management
Web-based Graphical User Interface
Limited Command Line Interface (via
Telnet)
SNMP support
DHCP client
DHCP Auto Configuration
Trap setting for destination IP, system
events, fiber port events, twisted-pair port
events
Password access control
Web-based configuration backup /
restoration
Web-based firmware backup/restore
Firmware upgrade using Web-based
management
Reset, Reboot
D-Link Green Technology
Power Saving: Enabled by default to save
power:
- By Link Status: Drastically save power
when the switch port link is down. For
example, no PC connection or the
connected PC is powered off.
- By Cable Length: Detects the length of
connected RJ-45 cables and adjusts power
usage accordingly without affecting
performance. Once the RJ-45 connection is
less than 20 meters, the switch will reduce
the power instead of full power, which is
only needed for 100 meters cables.
- By LED Shut-Off: LEDs can be turned
on/off by port or system through schedule.
- By Port Shut-Off: Each port on the system
can be turned on/off by schedule.
- By Port Standby: Each port on the system
enters sleep state by schedule.
- By System Hibernation: System enters
hibernation by schedule. In this mode,
switches save most power since main
chipsets (both MAC and PHY) are disabled
for all ports, and energy required to power
the CPU is minimal.