Filter
Top Products
DolbyRemote Installation and Operation Dolby Digital Parameters
4-18
For instance, you might want the Stereo Music preset to take effect at time code
00:12:22:12.
To do this, you follow the following procedure:
1.
Select the Time Code tab page
2.
Enter 00:12:22:12 in the Start Time Code field
3.
Select Stereo Music in the Preset Pending field.
When time code 00:12:22:12 occurs, the unit will switch to the Stereo Music preset.
The Preset Pending field will display None and the Current Preset field will
display Stereo Music.
There are a few restrictions on the recall preset on time code feature:
•
Once you have selected a start time and a preset, you can’t change the start time.
If you want to change the start time, you must follow this procedure:
1.
Select None in the Preset Pending field.
2.
Enter the new Start Time Code value.
3.
Select the correct preset in the Preset Pending field.
•
Pressing any of the preset buttons, immediately invoking a preset, cancels any
pending preset
•
If the unit is in Time Code Control mode, start and stop encoding is determined
by time code, it cannot also recall a preset based on time code. In other words, the
unit can either use time code to determine when to start and stop encoding, or to
determine when to recall a preset, but not both.
4.8.5 Resume
This button copies the Stop Time Code value to the Start Time Code value to
permit seamless encoding of two sections of continuous material.