Filter
Top Products
Dynaudio Evidence 7
Connecting
2. Connect the other cable ends to the loudspeaker outputs of your switched off power
amp (see Fig. 3).
Note:
X Please make sure that both loudspeakers are connected properly. For a better
distinction one of the two veins of most loudspeaker cables are marked.
– Connect the red marked post of the speaker to the red marked output of the amp.
– Connect the white or black marked post to the white or black marked output
accordingly.
Bi-wiring/bi-amping
Dynaudio loudspeakers feature a carefully fine-tuned cross-over, optimized using
selected parts and an advanced circuitry to achieve a truly balanced and smooth
frequency response. Therefore, dividing the frequency sections through bi-wiring or
bi-amping is not recommended.
Choice of loudspeaker cable
The impact a loudspeaker cable can have on sound quality may be dramatic, though in
general quality cable products will yield a quality result. Dynaudio loudspeakers are
designed to be very neutral and thus are not extremely suited to any particular type of
cable. The choice of cable is as much a factor of matching the cable to the entire audio
system. Please consult your Dynaudio dealer for information about compatible
loudspeaker cables that will suit both your electronics and the Dynaudio loudspeakers.
Connecting surround speakers
When connecting a two-channel stereo system, only the right and left channels are
connected to the amplifier.
In a surround set-up, center, side or rear loudspeakers as well as a subwoofer are
typically connected to provide for a multi-channel listening experience. Please refer to the
amplifier’s owner manual for particular connection instructions and see chapter “Multi-
channel loudspeaker setup” on page 12 for further help.
Fig. 3 Amplifier loudspeaker outputs (example).
Evidence
.
book
Seite
7
Montag
,
12
.
Januar
2009
2:04
14