Filter
Top Products
Page 11
SECTION 4
OPERATION
1. Turn TV and satellite receiver on.
2. Go to the signal meter screen on TV.
Choose transponder number: Dish Network #11
DIRECTV #19
3. Enter local ZIP code on signal meter screen to determine satellite
elevation. If you do not know your local zip code, determine your
elevation from the maps on pages 12-14.
4. Press and hold UP/ON arrow on King-Dome Controller for
3 FULL
SECONDS
to turn King-Dome on.
5. Press UP or DOWN arrow on King-Dome Controller to match
elevation on Controller to elevation on TV signal meter screen or
elevation from maps on pages 12-14.
6. Press and hold RIGHT arrow until Controller begins RAPIDL
Y
flashing its clock position (7-10 seconds). (See Fig. 2, Page 3.)
Remember, you must watch for signal strength on TV!
Dish will automatically perform a 360 degree scan for satellite.
When signal strength appears on TV, press ANY BUTTON to stop
the dish from rotating.
7. Press the UP, DOWN, LEFT or RIGHT arrows to fine tune signal
strength to the highest possible number on TV signal meter screen.
Enjoy your programming!
IMPORTANT! There must be a clear “line of sight” to the southern sky. Mountains,
buildings, trees, telephone poles, etc. can all block the satellite signal
from reaching the dish.
IMPORTANT! In Step 6, as soon as you begin holding the right
arrow, you must continuously monitor the TV
signal meter screen until signal appears on TV.
Note: The Controller will flash a series of codes and then display its
elevation. Wait for the Controller to steadily display the
elevation before continuing (about 10 seconds).