Filter
Top Products
36
Computer Input
Store
Exit the Image Adjust Menu.
Quit
Store icon
This projector has the picture screen resize function, which enables you to customize the image size.
Move the red frame
pointer to the function
and press the SELECT
button.
Screen Menu
Screen Menu icon
Screen Size Adjustment
Wide
Provide the image to fit the screen size.
Normal
True
Provide the image in its original size. When the original
image size is larger than the screen size (1024 x 768), the
projector enters to the panning mode automatically. Use the
Point ed7 8 buttons to pan the image. When adjusted,
the arrows will turn red. When reached to the correction
limits, the arrows will disappear.
Provide the image to fit the wide video aspect ratio (16:9)
by expanding the image width uniformly. This function can
be used for providing a squeezed video signal at 16:9.
Full screen
Provide the full screen image.
✔Notes:
•This Screen Menu cannot be operated when
720p(HDTV), 1035i (HDTV), or 1080i (HDTV)
is selected in the PC System Menu (p.30).
•This projector cannot display any resolution
higher than 1600 x 1200. If your computer’s
screen resolution is higher than it, reset the
resolution to the lower before connecting to the
projector.
•The image data in other than 1024 x 768 is
modified to fit the screen size in initial mode.
•True, Full screen, and Digital zoom +/– cannot
be selected when 480i, 575i, 480p, or 575p is
selected in the PC System Menu (p.30).
Press the MENU button to display the On-Screen
Menu. Use the Point 7 8 buttons to move the red
frame pointer to the Screen Menu icon.
1
Use the Point ed buttons to move the red frame
pointer to the desired function and then press the
SELECT button.
2
To store the adjusted data, select Store and press the
SELECT button. Use the Point ed buttons to select one
from Image 1 to 4 and press the SELECT button.
A confirmation box appears and then select [Yes]. Stored
data can be called up by selecting an “Image (1–4)” in the
Image Mode Selection on page 34.
Image Mode Menu
Move the red frame
pointer to an image
item to be set and
then press the
SELECT button.
A confirmation
box appears
and then select
[Yes]