–
16
–
EN
CLOSED CAPTION SYSTEM
You can view specially labeled (cc) TV programs,
movies, news, etc. with either a dialogue caption or
text display.
CAPTION mode: By choosing the caption mode, you
can watch dramas, movies and news while captioning
the dialogues and the contents of news.
TEXT mode: By choosing the text mode, you can
watch half screen text information if you want.
1-2: You may get these captions or text information
by selecting either “1” or “2”. Caption “2” is used,
usually for a second language if available.
NOTE:
Not all programs are broadcast with closed captions.
Your television is designed to provide error free
closed captions from high quality antenna, cable and
VCR signals. Conversely, poor quality signals are
likely to result in caption errors or no captions at all.
Common signal conditions which may cause captions
errors are listed below:
•
Automobile ignition noise
•
Electric motor brush noise
•
Weak snowy reception on TV screen
•
Multiplex signal reception displaying picture
ghosts or airplane flutter.
TV
NOTE:
If the unit displays a black box on
the TV screen, this means that the
unit is set to the TEXT mode. To
clear screen, select [CAPTION1],
[CAPTION2] or [OFF].
Make sure ...
•
unit power must be turned on.
1 Select “CAPTION”
Hit [SETUP] on the remote control.
Press
[
KK
/
LL
] to point to “CAP-
TION”.
2 Select your desired caption menu
Hit [ENTER] until your desired caption menu
appears.
([CAPTION1], [CAPTION2],
[TEXT1] or [TEXT2])
3 Exit the caption setting mode
Hit [SETUP] to return to TV mode.
NOTE:
•
Even if there is a power failure of any kind, the
unit will retain its memory for this feature.
TO CANCEL THE CLOSED CAPTION
SYSTEM
Repeat steps
1
to
2
, select [OFF] using ENTER. Hit
[SETUP] on the remote control to return to TV
mode.
- TV SETUP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [OFF]
- TV SETUP -
CHANNEL SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
B CAPTION [CAPTION1]
T
he Sleep Timer function enables you to shut off the power
without hitting [POWER] after a desired time period.
1 Set “SLEEP TIMER”
Hit [SLEEP] on the remote control.
You may change the sleep time
with hitting [SLEEP] repeatedly.
The timer is set up to 120 minutes,
30 minutes each time SLEEP is
pressed.
NOTES:
•
When you disconnect the unit from the AC outlet,
or if you have a power failure, the sleep time will
be lost.
•
To view the time left for sleep timer, hit [SLEEP]
once when SLEEP display disappears. After 10
seconds, display will disappear again.
To cancel the sleep timer:
Hit [SLEEP] repeatedly until “SLEEP 0 MINUTE”
is displayed.
TV
SLEEP 120 MINUTE
SLEEP TIMER