Emerson EWC27T3, EWC19T3 TV DVD Combo User Manual


 
- 34 - EN
1C29
TO CHECK THE BEGIN/END TIME
1)Press the POWER button so that the RECORDING
indicator goes off.
2)Press the SETUP button on the remote control.
3)Confirm TIMER PROGRAMMING is pointed.
4)Press the ENTER button. The details of programs
appear on the TV screen.
5)Press the SETUP button on the remote control to
return to TV mode.
HINTS FOR AUTOMATIC
TIMER RECORDING
Make sure the channel you want to record is prop-
erly set in advance.
It is not necessary to press the RECORD button for
timer recording.
Recording begins automatically at the Start time.
If you are recording using a Timer mode, you may
not operate the TV/VCR/DVD manually.
The erase-prevention tab on the cassette must be in
place (or you must put tape over the hole).
If the erase-prevention tab is removed, the cassette
will be ejected when the POWER button is pressed
to off.
If the tape runs out before the end time, the
TV/DVD/VCR will switch to the Stop mode
immediately, and the tape will be ejected.
TV/VCR
AUTO RETURN
With this feature, after timer recording is finished,
the beginning of the recorded program(s) can be
searched for automatically.
1 Select USERS SET UP
Press the SETUP button on the
remote control.
Press the Arrow button
K or L to
point to USERS SET UP.
Then, press the ENTER button.
2 Set AUTO RETURNto [ON]
Press the Arrow button K or L to
point to AUTO RETURN.
Press the ENTER button until [ON]
appears.
TV/VCR
3 Auto Return will begin
When all the timer recordings are completed, the
TV/DVD/VCR will rewind to the beginning of the
recorded program(s).
NOTE:
If you press the POWER button while tape is
rewinding, the Auto Return will stop.
4 Watch the recorded program
Press the PLAY button.
TO CANCEL THE AUTO RETURN
MODE
Repeat steps [1] and [2], select [OFF] using the
ENTER button.
If there is a power failure of any kind, the
TV/VCR/DVD will retain its memory for this fea-
ture.
- TV/VCR SETUP -
TIMER PROGRAMMING
SETTING CLOCK
CHANNEL SET UP
B USERS SET UP
V-CHIP SET UP
LANGUAGE [ENGLISH]
CAPTION [OFF]
ZERO RETURN
TIME SEARCH
INDEX SEARCH
USERS SET UP
RENTAL [OFF]
REPEAT PLAY [OFF]
B AUTO RETURN [ON]
VCR AUDIO [HIFI]
TV AUDIO [STEREO]
SLEEP TIMER
The Sleep Timer function turns off the
TV/DVD/VCR without using the POWER button
after a desired period of time.
NOTE:
This function does not operate during Recording
mode.
TV/VCR
1 Select SLEEP TIMER
Press the SLEEP button on the remote control until
SLEEP TIMER appears.
2 Set sleep time
Press the SLEEP button until your
desired sleep time appears.
Each additional push will increase
the time by 30 minutes up to 120
minutes.
After 5 seconds, exit the Sleep Timer setting.
TO CANCEL THE SLEEP TIMER
Press the SLEEP button on the remote control until
SLEEP TIMER appears. Press the SLEEP button
until SLEEP 0 MINUTES appears.
SLEEP 120 MINUTES
TD853/953(P01-35).QX33 03.2.28 11:00 PM Page 34