Filter
Top Products
4
EN
I
NTRODUCTION
Symbols Used in this Manual
The following is the description for the symbols used in this manual.
Description refers to:
DTV
: Digital TV operation
TV
: Analog TV operation
If neither symbol appears under the function heading, operation is applicable to both.
5
•
If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters).
Contact your local electronics store for these items.
•
•
Supplied Accessories5
owner’s manual
(1EMN22446)
quick start guide
(1EMN22447)
remote control
(NF020UD)
batteries
(AA x 2)
Phillips pan screw for
attaching the stand x 4
(FPH34100)
Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
5
front side
front side
front side
screw holes
front side
Trademark Information
HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI
Licensing LLC.
Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby
Laboratories.
Product that have earned ENERGY STAR® are designed to protect the environment through superior energy efficiency.
5
•
•
•
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
• If you removed the stand shafts from this unit for wall mounting, make sure that you attach them before attaching the stand.
1
Spread a thick and soft cloth over
a table.
Place the main unit face down
onto it.
Make sure not to damage the
screen. At least two people are
required at this step.
2
Insert the stand all the way to the
main unit slowly.
Make sure not to put the AC cord
between the stand and the unit.
3
Drive Phillips pan screws in the
4 threaded holes at the bottom
of the stand with a screwdriver
tightly.