Filter
Top Products
Turn on the DVD player Turn on the DVD player
Basic playbackBasic playback
Standby Mode :
Play/Pause: If disc playback is stopped,
press this key to make player start again.
If in the pre - stop condition it executes
memory play function. During disc play-
back, press once to pause; press again to
resume playback.
Stop: Stops disc playback. Press once to
stop the disc playback. (Playback will start
at location where you stopped.) Pressing
twice will cause a full stop. (Playback will
start at the beginning the disc).
Previous Chapter/Next Chapter: When you press this key, the player will skip to
the Previous/Next chapter or track and play automatically.
Play/Pause
Stop
Fast forward
Fast reverse
LCD Mode
Previous
Basic Operations
Power
7
8
Next
LCD Mode: The Mode button brings up the LCD picture menu. You can adjust the
picture options: COLOR, CONTRAST, BRIGHTNESS, HUE, REVERSAL, NORMAL
and RESET using the arrow and ENTER buttons to make adjustments.
COLOR: adjusts the richness of color.
CONTRAST: adjusts the difference between the light and dark areas.
BRIGHTNESS: adjusts the brightness.
HUE: adjusts the balance between red and green levels.
REVERSAL: turns the image upside down.
NORMAL: adjusts the 4:3 or normal LCD screen format.
RESET: adjusts all MODE options back to the factory settings except NORMAL .
Fast forward/Reverse: When you press
the Fast forward/Reverse key during
playback, the unit will Fast forward/
Reverse the disc. With each consecutive
press of the Fast forward/Reverse key,
the playback speed increases. There are
4 speed levels for DVD discs in FWD/ REV:
2x,4x,16x,100x. For all other discs, there
are 3 speed levels: 2x,4x, 8x. Press the
Play key to resume normal playback.
1.Set the player on a table or on a steady surface.
2.Raise the screen to the open position.
3.Press the Power key of the remote control to turn on the unit, you can also press
and hold the On/Off button for 3 seconds to turn on the unit.
4.When the power is turned on . The player will automatically search for the disc.
If a compatible disc is available, the unit will start the disc playback automatically.
(1). Press Power key to turn off the disc play-
back when the unit is on.
(2). When the unit is off, press Power key to
startd disc playback again.
(3). Disconnecting the main power to the
device will end the standby state.
When the unit is stopped or paused, and no
operations are performed within 5 minutes,
the screen saver mode will be activated auto-
matically.
.
To save battery power, the unit has an auto-
screensaver and auto shut-off function.
After the screensaver has been on
for 5 minutes, the unit will turn off automati-
cally without the resume play feature
Note: