Filter
Top Products
3 Align the slot in the filter with the tab on the TV. Press the filter in place over the air intake vent.
4 Press down on the filter to make sure the adhesive is secure.
5 Replace the speaker cover.
Cleaning the Air Filter
Once the air filter is installed, you need to inspect it regularly. If the filter appears to be dirty, clean it as described below.
Note
Whenever you inpect the front air filter, you should also check the air filter on the left side of the TV and clean it if necessary. The
location of this filter is shown in your User’s Guide. You can clean the side filter using the same method that you use to clean the
front filter.
1 Remove the right speaker cover.
2 If the filter looks dirty, clean it using one of these methods:
• Use a computer vacuum cleaner or the upholstery brush attachment for your home vacuum cleaner to lightly
vacuum the filter and remove the dust. If your home vacuum cleaner has an air bleed valve (located near the
end of the hose where you attach the cleaning tools), you should open the valve to decrease the amount of
suction.
• Use a clean paintbrush with very soft bristles to lightly brush off any dust from the crevices.
3 Replace the speaker cover.
Epson and Livingstation are registered trademarks and Epson Exceed Your Vision is a trademark of Seiko Epson Corporation.
© 2007 Epson America, Inc. 7/07 CPD-24509
Align slot with tab on
air intake vent
Make sure adhesive
is secure