Filter
Top Products
Fine-Tuning the Projector 51
The default setting for the Password Protect function is Off. Follow
these steps to turn password protection on:
1. Press the
Freeze button on the remote control for about five
seconds.
You see this screen:
2. Use the pointer button to set
Power On Protect to On. Then
press
Enter.
3. Press
Esc.
4. Select Password and press Enter.
5. When you see a message asking if you want to change the
password, select
Yes and press Enter.
6. Hold down the
Num button on the remote control and use the
numeric keypad to enter a four digit password. (The default
setting is 0000.)
7. When you see a confirmation message, reenter the password.
Then press the Menu button to exit the screen.
8. Press the
Num button on the remote control to deactivate the
numeric keypad.
9. If you want to disable the password temporarily, select
Timer and
press
Enter. Then hold down the Num button while you use the
numeric keypad to enter the number of hours (from 0 to 9999)
that you want the password feature disabled. If you want the
projector to request the password every time it is turned on, set
the timer to
0H.
caution
If you lose the remote
control, you will not be able
to enter the password. Keep
the remote control in a safe
place at all times.