Filter
Top Products
Operation
8
(1) Insert a HDD (IDE) for Video Storage
(2) Connect cable for video/audio input and video/audio out,
The detail connection is described in SYSTEM CONNECTION.
(3) Switch Power On
(4) Press MENU key to enter SET UP MENU.
Once inside the main menu you will find there are 17 set up pages as below:
Selected item will be surrounded by a white block.
MENU
(5) Turn the JOG dial clockwise or counter-clockwise to select the item,
press ENTER key for detail set up for each item.
5. Operation
Insert one or two HDD (3.5”IDE) for Video Storage.
The HDD should be set as Cable Select or MASTER. Both HDD need equal setting.
(Normally the default setting of HDD is Master)
Note: After hard disk case is inserted into the hard disk tray, be sure to turn the tray key
in lock position.Otherwise, HDD will not be detected.
ATTENTION: Changing HDD s and switching on HDD s is not allowed in record mode!
(6) Press MENU again to leave the set up menu.
The LCD panel in the front panel will light when you switch on the power.