Filter
Top Products
MENU
21
(3) PRE-ALARM RECORD: (with Alarm In and Motion)
Pre-alarm duration is depending on recording quality (about 8-15 seconds).
OP (Operation): Select ON to activate or OFF to deactivate pre-alarm recording.
(4) PERMANENT RECORDING:
This recording mode is used for continuous recording in the quality of NORMAL
RECORD settings.
Permanent record option:
Operation: ON or OFF
Speed : 0.01 IPS, 0.3 IPS, 0.5 IPS, 1 IPS, 5 IPS, 10 IPS, 15 IPS, 20 IPS,
30 IPS, and 60 IPS.
IMPORTANT NOTE:
This mode is recommended in combination with alarm records (alarm contacts or
motion alarm). If only alarm recording is active, the hard disk capacity is not used
optimal because every alarm record opens a new segment on the hard disk. Depending
on the alarm settings (duration, quality), this segment is not used totally and results in
the total EDSR recording time being less than expected.
By activating a NORMAL or PERMANENT recording with low recording rate - from
version 1.08 the EDSR900/1600 also supports 0,01 IPS (1 picture every 100 seconds) -,
this effect can be avoided. All records will continuously be written in one segment and
the Hard Disk is used up to its full capacity.
When device had been set to be “PERMANENT”recording, and the device will follow
“PERMANENT”setting when Rec bottom not been pushed(Device power on). If users
push the Rec bottom, and it is “Normal”recording type.
Turn the JOG dial clockwise or counter-clockwise to select the options.
Press MENU key to return to Main Menu, press again to leave Set up Menu.
MENU
Press ENTER key to confirm the option and move to next column.
ENTER