Filter
Top Products
EVERFOCUS ELECTRONICS CORPORATION
Dwell Time: This field represents the rate at which the cameras will
sequence on the call monitor. The dwell time for the auto sequence
can be set from 0 to 99 seconds. To change this, simply use the Jog
Dial on the DVR. Press the Enter key to make your selection.
Event: This field is to select what to do if an alarm or motion occurs.
The default is set to none. If you set this to motion then if motion is
detected the camera will be displayed. After the alarm record duration
has passed the monitor will switch back to standard sequence. To
change this, simply use the Jog Dial on the DVR. Press the Enter key
to make your selection.
37