Filter
Top Products
Cable Cubby 200 • Installation 8
3. Install Any Necessary Split Grommets and
Hole Plugs
a. Slip the appropriate split grommet over each
cable with the flange of the grommet toward
the connector that will be accessible inside
the Cable Cubby. Snap the grommets into the
channels.
b. If necessary, snap the included hole plugs into
unused holes.
4. Adjust the Cable Position
The Cable Cubby 200 has four cable stand-offs that
set the height of the cables inside the enclosure.
a. Choose the row that best lifts the cable
connectors off the cable pass-through AAP and
still allows the lid to be closed.
b. Insert the stand-off into the Cable Cubby and
align the ends with opposing horizontal slots in
the side of the enclosure.
c. Loosely install the Phillips head screws and
washers so the stand-offs remain attached, but
can be easily adjusted within the slots.
d. Install a second stand-off next to the first
stand-off, in accordance with steps 4a, 4b, and
4c.
e. Slide the stand-offs back and forth in the
horizontal slots to position them so that the
cables easily rise and lower but do not fall
below the stand-offs.
f. Tighten the Phillips head screws of the
stand-offs to lock them into position.
g. Repeat steps 4a through 4f until all the cable
connectors have been accompanied with
stand-offs.
5. Install Optional Passive AAPs
The pass-through AAPs can be replaced with
Extron passive AAPs.
a. Unscrew the nuts on the underside of the shelf
that fasten the set of pass-through AAPs to the
enclosure.
b. Connect cables to the rear of the AAPs to be
installed before attaching it to the enclosure.
c. Insert the screws of the AAPs through the holes
in the shelf. Secure the AAPs to the shelf with
the provided captive washers and #4-40 nuts.
Cable Stand-off
Ü
á