Filter
Top Products
DTP T HWP 231 D and DTP T HWP 331 D Transmitters • Installation and Operation 11
Power Supply Wiring
NOTES:
• Only one power supply is required. A single power supply connected to either unit
in the pair powers both units.
• A power supply is included with each individually-packaged transmitter.
• Do not tin the power supply leads before installing them in the direct insertion
connector. Tinned wires are not as secure in the connectors and could be pulled
out.
Figure 9 shows how to wire the connector. Snap the provided ferrite bead onto the DC
power cable, between the power supply and the connector on the HDMI unit.
SECTION A–A
AA
Power Supply
Output Cord
Captive Screw
Connector
Ridges
Smooth
3/16"
(5 mm) Max.
Figure 9. Power Connector Wiring
CAUTION: The two power cord wires must be kept separate while the power supply is
plugged in. Remove power before wiring.
ATTENTION : Les deux cordons d’alimentation doivent être tenus à l’écart l’un de
l’autre quand l’alimentation est branchée. Couper l’alimentation avant de faire
l’installation électrique.