Filter
Top Products
Appendix, cont’d
DVS 406 • AppendixA-10
7. Insert the card’s installation screw through the SDI card’s mounting hole
and gently tighten it into the standoff.
8. Install the SDI connector’s hex nut and keep the SDI card from twisting as
the nut is tightened.
9. Replace the top cover on the DVS 406 scaler, and fasten it with the screws
that were removed in step 3.
10. Rack/furniture mount the scaler, connect the input/output cables, and
reconnect the AC power cord.
20-pin socket on
back of SDI card
20-pin connector
on main board