Filter
Top Products
V-Lock
™
Wall Mount Assembly Kit • Installation
3
Installation, cont'd
5. Carefully remove (and retain) the mounting screws,
taking care not to damage the mounting holes in the wall.
Remove the mount from the wall.
6. Remove a new V-Lock
™
assembly from its box, loosen the
hex cap screw and rotate the front section approximately
90 degrees to the mounting plate, (see figure 3). Lightly
tighten the hex cap screw to temporarily lock it in position,
allowing access to the mounting holes in the wall plate.
7. Pass the wire through the access hole in the wall plate and
using the existing mounting holes and screws, securely
mount the new assembly wall plate to the wall.
N If the mounting holes in the wall are damaged and
unusable, or a new location is desired, create new
mounting holes, following the instructions in
the SI 26 and SI 28 User's Manual.
8. Loosen the hex cap screw and turn the stage back through
90 degrees to its upright position and lock into place.
9. Reattach the seismic cable to the speaker as shown.
Seismic Safety Cable
Attach line here
and secure.
Anchor this end to a
suitable secure point.
Figure 4 — Re-attach the seismic safety cable
10. Mount the speakers onto the assembly, following the
instructions in the next section.
Mounting the speakers
The two models of speakers (SI 26 and SI 28) have slightly
different mounting procedures. Follow the applicable method.
Mounting the SI 26 speaker onto the wall mount assembly
1. Carefully lift the speaker above the wall mount assembly
and gently slide the speaker box bracket down into the
V lock groove (see figure 5) until it locks into place.