Filter
Top Products
UNPACKING
Remove the NR Series unit from the shipping con-
tainer and examine it for any signs of shipping
damage or missing items (check inventory list
below). All shipping materials should be saved if
the unit is to be moved or returned for service.
INSTALLATION
The processor can be either placed on a table or
rack mounted. If the rack mounting installation kit
is used, the rack mount ears are mounted by using
3 screws. It will be necessary to support the rear of
the unit if it will be shipped in the rack by using
rack support rails supplied by the rack manufac-
turer.
VENTILATION
The unit uses convection to cool. A fan is not
needed. As hot air raises out of the top vent, cool
air is drawn in from the bottom. These vents must
not be blocked. When rack mounted, a minimum
of 1.75” (1 rack unit height) of free space is
required above and below the unit to allow for
proper cooling. A forced air fan should be added
to the rack installation if power amps are located in
the same air space.
REAR PANEL I/O
Inputs
1. S-Video (4 Pin DIN)
2. Composite Video (BNC)
3. Interlaced Component (480i) or RGBs Video
(BNC)
4. HDTV/Computer (D15M)
10. AC Power
Outputs
5. RGBH/CV or YPrPb (D15F)
6. RGBH/CV, or YPrPb (BNC)
Note: Both outputs can be used simultaneously
Control
7. Screen Trigger (12V, 3.5mm, 2 pin, Tip=+ )
8. Remote IR sensor (5V-12V, 3.5mm, Tip=+)
9. RS232 Port (D9F)
2
INSTALLATION
Inventory
1-NR Series Unit 1- Remote + Batteries
1-Owner’s Manual 1- Warranty Card
1- Power Cord
12 3
4
56789 10