Filter
Top Products
Wheel
Retainers
Grooves
• Position the base/handle covers so that the flared end
faces the front of the trike.
• Fit the base/handle covers onto the trike rear frame near
the rear wheels.
• Insert two #10 x
3
/
4
" screws through each handle cover
and tighten.
Assembly
Assembly
• Place the base/handle assembly on a flat surface so that
the wheel retainers are upright.
• Fit the trike onto the base/handle assembly so that the
rear frame rests in the grooves in the base and the front
wheel fits between the wheel retainers in the base/handle.
17
Base/Handle
• Fit the handle top and bottom to the end of the base,
as shown.
• Insert 13 - #8 x
3
/
4
" screws into the handle top and tighten.
16
Handle Top
Base
8
8
Handle Bottom
Base/Handle
Flared End
Trike
Handle
Cover
18
Handle
Place Center
of Label Here
Center of Label
• Before applying the label, wipe the surface of the
handle with a clean, dry cloth to remove any dust or oils.
• Remove the backing from the label.
• First, position the center of the label on the handle,
as shown. Then, smooth each end of the label outward to
attach it to the handle.
• For best results, avoid repositioning a label once it has
been applied to the handle.
19
B2488 RRR Trike Deluxe 4/17/03 2:07 PM Page 8