Filter
Top Products
16
MAIN MENU
MAIN MENU
4.3 Upgrade By RS-232
1. Press keys to select among allcode,
maincode,card,Radioback,keydate defaultdb,
userdb. The default option is allcode.
2. Press OK key at the Start button to start checking
serial port.
1.Upgrade File: Show the Upgrade File.
2.Upgrade Mode: Select among AllCode, maincode, conaxca, radioback, bootlogo
and Dump. When users switch the upgrade mode, Upgrade File will show the
corresponding le according to the table below:
4.5 Upgrade by USB
3.Press OK key on start button to start receiving the data from USB device.
When the USB device is not connected, this item is grey , you can not edit it now.
Upgrade Mode File feature
All code : File named as "*.abs"
Main Code: File named as *.abs
Radio back: File named as "*.abs", the picture
will be used as both radio back and
menu back
bootlogo: File named as "*.abs"
Select the upgrade mode and upgrade le, then you can start upgrade by USB.
4.4 S/W Upgrade by OT A
1. Frequency: Use numeric keys to input the proper
value.
2. Bandwidth: Select among 6, 7, 8MHz.
3. Down load PID: Use numeric keys to input the proper
value.
3. Start: Press OK key to start upgrading.
If no correct searching information, system will inform
"Collecting information". You can press Exit button to
return to the previous window.
System will start upgrading after collecting information
successfully. Press OK key at the Download button and
press OK key at the Burnash button to start burning.
After booting, press OK key at the Reboot button to
reboot.