Fujitsu P42HCA10 Flat Panel Television User Manual


 
E-31
English
Minimizing phosphor burn-in (Screen Orbiter) for RGB
You can use this option to move the screen position to minimize phosphor-induced burn-in.
Follow the steps below.
(1) Select Screen Orbiter and press .
The Screen Orbiter setting screen will appear.
(2) Press or to select Mode/Time.
(3) Select a desired pattern.
Each time you press or , one of the available choices appears in the following sequence:
Off: Disables Screen Orbiter.
Time: Moves the pattern approximately every one hour.
Mode: Moves the pattern when the power is turned ON or when you switch between modes.
(4) Press or to select Moving Area.
(5) Press or to select the range for moving the pattern.
Each time you press or , one of the available choices appears in the following sequence:
Min.: Pattern moves in small range. (About 5 pixels)
Std.: Pattern moves in moderate range. (About 10 pixels)
Max.: Pattern moves in wide range. (About 15 pixels)
(6) Press to store.
Input mode of priority (Input Priority)
You can use this option to switch between modes only when a signal is received through the
selected input mode terminal. You cannot switch the input mode.
Each time you press or , one of the available choices appears in the following sequence:
Off: Switches between modes normally.
Other modes: Displays pictures when a signal is received through the selected input mode
terminal.
Press to store.
When using the display continuously
When switching between RGB and video input modes only
occasionally
(1) Select Time for Mode/Time with Screen Orbiter.
(2) Select a desired range for Moving Area with Screen Orbiter.
This causes the screen saver pattern to move in the same range at
regular intervals.
When switching between RGB and video input modes
frequently
(1) Select Mode for Mode/Time with Screen Orbiter.
(2) Select a desired range for Moving Area with Screen Orbiter.
When the mode is switched from Video to RGB, the display position
moves.
When using the display occasionally
Select a desired amount of time for DPMS.
Thus, when the display does not receive a signal, it will automatically
display white or black over the entire screen. When the predetermined
time elapses, the power will turn OFF.
Using screen protection functions (examples)
The screen protection functions minimize phosphor burn-in but cannot completely eliminate it.
Screen Orbiter setting screen
* On-screen information disappears if you do not take any action for about 60 seconds.
03.1.20, 13:20Page 31