Filter
Top Products
English
E-37
• D-SUB Input
You can use this option to select the signal system it will receive to D-SUB Input terminal.
(1) Select D-SUB Input and press .
D-SUB Input screen appears.
(2) Select the signal system to receive.
Each time you press or , one of the available choices appears in the following sequence:
RGB-PC Decoder
RGB-PC: For using RGB for PC.
Decoder: For using digital broadcast tuner.
(3) Press or to select Mask.
(4) Select Decoder by FUNCTION to set up Mask.
Each time you press or , one of the available choices appears in the following sequence:
Off: Does not mask.
Number: Masks the fringe (top, bottom, right and left) of the screen by the number of pixels
specified.
(5) Press to store.
• DVI Input
You can select the signal method input to the DVI input terminal.
Each time or is pressed, the setting is changed.
DVI1 DVI2
DVI1: Used when connecting to a PC.
DVI2: Used when connecting to a DVD player or digital tuner.
Press to store.
* Set according to the signal method before connecting peripheral device.
“D-SUB Input” selection screen
This fringe part is masked.
* On-screen information disappears if you do not take any action for about 60 seconds.
03.1.16, 12:00Page 37