Filter
Top Products
E-10
BASIC OPERATIONS
TURNING THE POWER ON AND STAND-BY
1
Press
/I to the left at the bottom of the display to the ON
state.
The power lamp lights up.
2
Press on the remote control.
The color of the power lamp changes from “Red” to “Green”.
3
Press " – ' or ).
Select the video mode to input.
4
Press when the power is ON.
The color of the power lamp changes from “Green” to “Red” and the the power turns “OFF (Stand-
by state)”.
ADJUSTING THE VOLUME
Adjusting the volume
Press
1
to increase the volume.
Press
2
to reduce the volume.
* Note that the volume level remains stored even when you
turn OFF the power.
Muting the audio
Press
-
.
The audio is removed.
Press again to restore the audio to the original level.
The mute mode can also be released by pressing the volume buttons.
VIDEO INPUT MODE
1
Press "-' to select the input
mode.
You can select from VIDEO1 mode to VIDEO6
mode.
The video modes corresponding to each input
terminal are as follows.
•VIDEO1: Video
• VIDEO2: S-video
• VIDEO3: Component video
• VIDEO4: Component video
• VIDEO5: HDMI
• VIDEO6: HDMI
* For selection of the input terminal, see “SETTING THE INPUT TERMINALS” on P. E-24.
* You can also use the buttons
on the display’s control
panel to perform these steps.
Note
• Functions may not be available with some models and some device options.
* You can also use the buttons
on the display’s control
panel to perform these steps.
When the volume adjustment button is
pressed
* You can also use the buttons
on the display’s control
panel to perform these steps.
Video1 mode
7527_E.book 10 ページ ２００６年９月５日 火曜日 午後９時３５分