Filter
Top Products
3. STEERING MODES
3-4
3.3 NAV Mode
3.3.1 Starting the NAV mode
If a destination waypoint is set on a GPS / Plotter, the NAVpilot-511/520 can
receive this information and guide the boat to the destination waypoint as
determined by the plotter. To use the NAV mode, complete the following steps.
Note: It takes 15 seconds to activate the NAV mode after the NAVpilot-511/520
receives the above information.
1. Set the destination waypoint (or route) on the plotter.
2. Manually steer the boat towards the waypoint.
3. Press the [NAV] key.
You are asked which port is used for the NAV mode PORT 1 or PORT 2
( depending on menu setting) . Press the course control knob to go to the NAV
mode..
NAV
359.9
Heading control mode
(Indicated with underline)
Course to the
destination waypoint
Rudder angle (XTE or Deviation)
Heading from
heading sensor
HDG
M
RUDDER
0
40
20
10 5
40
20
10
Heading mode
M: Magnetic
T: True
359
SRC: PORT1
Selected
Navigator
5
NAV mode display (Ex. Normal Display 2)
Note that while in the NAV mode, the course reading on the NAVpilot-511 will not
always be the same as the waypoint direction shown on the plotter.
When you want to navigate a route, make sure that your plotter is navigating
towards the nearest or desired waypoint before putting the NAVpilot-511 into the
NAV mode.
4. Press the [STBY] key to terminate the NAV mode.
Note: You can switch the source port between PORT 1 and PORT 2 by pressing
the [NAV] key more than three seconds.