Filter
Top Products
Learn Commands
Now you’re ready to have your RM24941 learn the commands from your
existing remotes. All Learned keys are saved automatically. Remember, only
one original remote can be stored under any one mode. The RM24941 can
learn the commands for one TV remote, one VCR remote, one DVD remote,
etc.
1. Point the top of the original remote at the base of the RM24941 so the IR
LED on the original remote is in line with the RM24941 Learning sensor,
located at the bottom of the remote. The remotes should be positioned
two to three inches apart.
2. Press and hold the SETUP key on the rubber keypad until the LED indi-
cator light remains on and the touchscreen shows the Main Setup Screen.
This process takes approximately 2-3 seconds.
3. Release the SETUP key.
4. Press and release the LCD LEARN key. The LED indicator light blinks
once to indicate acceptance of the keypress.
5. The touchscreen now shows the Device Setup Screen. Press and release
the device key on the rubber keypad that corresponds to the remote you
want the RM24941 to learn (TV, VCR, SAT/CBL, etc.). The LED indicator
light blinks once to indicate acceptance of the keypress.
6. The touchscreen now shows the Learn Setup Screen 1, which displays the
current screen keys for the mode you have chosen. The LCD SETUP and
LEARN keys are also shown.
7. Press and release the key on the RM24941 to be taught. (Remember: You
can switch between the screens displayed by pressing the LCD SCREEN
key.) The LED indicator light blinks once to indicate acceptance of each
keypress.
8. Now, press and hold the key on the original remote until the LED
indicator blinks once and the touchscreen shows Learn Setup Screen 2.
This process takes 2-3 seconds to complete.
9. To learn another key, press and release the LCD LEARN key and repeat
from Step 7.
10.If a problem occurs with the Learning process, the LED indicator light
flashes for two seconds and you hear three beeps, but the unit remains in
the Learn routine with Learn Setup Screen 1 displayed. Repeat from Step
6.
11. To save and exit from the Learn routine, press and release the LCD OK
key. The touchscreen returns to the Main Setup Screen.
12.The Learning process is now complete.
13.Press LCD CLEAR on the Main Setup Screen to exit Setup Mode.
Note: Learned keys will beep twice when pressed if keypress beep is
turned on.
10
24941manual 8/13/03 8/19/03 8:42 AM Page 12